With this tutorial, you will learn how to get the weather data from a web service to your Arduino. Things used in this project Hardware components Arduino MKR1000 × 1 Story In this tutorial we would make use of the WiFiConnection of our mkr1000. We will get weather forecast of and activate the relay, connected […]
Getting weather data using Arduino Read More »
This project is a platform for drinking water monitoring and analytics, consists of IoT device, cloud, and mobile and web app. Things used in this project Hardware components Arduino MKR1000 × 1 PCF8574 × 1 AC-DC Module 5V 500mA × 1 10 Segment LED Bar Graph (Red) × 1 Resistor 100 ohm × 11 Resistor
Project “Gallon” – Smart Drinking Water Monitoring Platform Using Arduino Read More »
All embedded lovers are familiar with multimeter which a great tool to measure voltage, current, resistance etc. A multimeter can measure them easily. But sometimes we need to measure inductance and capacitance which is not possible with a normal multimeter. There are some special multimeters that can measure inductance and capacitance but they are costly.
LC Meter using Arduino: Measuring Inductance and Frequency Read More »
As electronics engineers, we always depend upon meters/instruments to measure and analyse the working of a circuit. Starting with a simple multimeter to a complex power quality analysers or DSOs everything has their own unique applications. Most of these meters are readily available and can be purchased based on the parameters to be measured and
Arduino Wattmeter: Measure Voltage, Current and Power Consumption Read More »
The purpose of this project was to design a functioning digital meter to measure voltage, current, and resistance to a known accuracy. Read more: Digital Multimeter
Digital Multimeter Using Arduino Read More »
Three-fourths of the earth is water, out of which 97 per cent is saline (in oceans, seas and groundwater). The remaining 2.5 per cent to 2.75 per cent is fresh water , out of which 1.75 per cent to two per cent is frozen in glaciers, ice and snow. Fresh groundwater and soil moisture constitutes
Microcontroller Projects: Sonar Water-Level Meter Using Arduino Read More »
Presented here is a IoT enabled air pollution meter to monitor air quality on your smartphone using Blynk application and Arduino board. Blynk is an Internet of Things (IoT) platform to control Arduino, Raspberry Pi and the like over the Internet. In this project Blynk provides a digital dashboard on your smartphone that displays real-time
IoT-Enabled Air Pollution Meter With Digital Dashboard On Smartphone Using Arduino Read More »
Precise measurement of line signal frequency is very important in many applications, especially in the management of power grid systems. Tasks like calibration of governors of engines that run generators in power plants need a resolution up to 0.01Hz. Frequency is also an important parameter in load sharing among several power plants in the grid.
Line Frequency Meter Based On Reciprocal Counting Using Arduino Read More »
Microcontroller based miniscule event counter presented here is based on the inexpensive Digispark Attiny development board. One advantage of this design is that any type of active or passive switch can be connected to its trigger input. Whenever the switch closes event will be counted inside the microcontroller and would be displayed on the 4-digit
Simple Event Counter Using Arduino Read More »
A digital soil moisture meter is used for indicating the water content of a given soil sample. As crop production requires water at different stages and in different amounts, it is important to measure soil moisture from time to time to know its status. The digital soil moisture meter circuit presented here, for monitoring the
Digital Soil Moisture Meter Using Arduino Read More »
